AD-SYNCHRONA14-EBZ

AD-SYNCHRONA14-EBZ is an ideal self-contained device to use in evaluation and prototyping of applications that need a highly accurate frequency and phase-controlled source clock. It is designed around AD9545 and HMC7044 and greatly simplifies clock distribution and multi-channel synchronization in complex systems. It is intended to be used by trained professionals in a laboratory environment and not intended as an end product for commercial use. It can be taken as a complete reference design and customized as required for any end customer applications. It comes in a 1U mechanical form factor. Using popular industry connector SMA and TwinAX interfaces most labs will already have the needed cable. Typical . Applications include high accuracy reference clock distribution, systems clocked from a single source, clocks derived from 100/122.88MHz, phased array systems, RADAR, EW, SATCOMS, SDR, bench equipment and remote controlled operation.

• Raspberry Pi 4, ARM Cortex-A72, 2GB SDRAM
• Gigabit Ethernet, 2xUSB 3.0, 2xUSB 2.0 ports, SPI interface, GPIO, 2 bicolor LEDs, male pin header
• HMC7044 (high performance, 3.2GHz, 14-output jitter attenuator)
• AD9545 (1 PPS synchronizer and adaptive clock translator)
• 4 x TWINAX LVPECL AC&DC coupled, 2 x SMA LVPECL AC coupled, 4 x SMA CMOS, 4 x SMA LVDS AC coupled
• 3 differential 100 ohm SMA clock inputs, PPS input, SYNC input, 10MHz input
• 100MHz and 122.88MHz ultra-low phase noise VCXO's (-165dBc/Hz)
• 40MHz and 38.4MHz TCXO's (±1ppm) 50MHz OCXO(+/- 10ppb)
• Internal references are software configurable
• DC 12V, 3A barrel jack

Contents

AD-SYNCHRONA14-EBZ, 12V power supply, Rack mounting flanges, Voltage level adaptor add-on board.

Notes

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party