MCB1850U

MCB1850U is a Keil MCB1800 evaluation board with ULINK2 debug adapter. Board enables to create and test working programs based on the NXP LPC1850 ARM Cortex-M3 processor based device. The NXP LPC1850 microcontroller provided with the MCB1800 board is a high end LPC devices with on chip CAN, Ethernet, USB (full and high-speed) connectivity. A 12MHz oscillator provides the clock signal for the MCU. The JTAG/Cortex debug Interface connector provides debugging and emulator support for the LPC1850 device. The JTAG/Cortex debug Interface allows application debugging and programming of on chip and off chip flash devices. And also supports the Serial Wire Mode of Cortex-M3 based devices. The MCB1800 board connects the on chip serial UARTs to the ST3232C, which converts the logic signals to RS232 voltage levels. ULINK2 debug adapter connects PC's USB port to target system and allows to program and debug embedded programs on target hardware.

• 180MHz ARM Cortex-M3 processor based MCU in LBGA256
• On chip SRAM 200KB
• On board memory of 16MB NOR flash, 4MB Quad SPI flash, 16MB SDRAM, and 16KB EEPROM (I2C)
• Colour QVGA TFT LCD with touch screen
• 10/100 Ethernet port
• High speed USB 2.0 Host/Device/OTG interface, Full speed USB 2.0 Host/Device interface
• CAN interfaces, serial/UART port, MicroSD card interface
• Audio CODEC with line In/Out and microphone/headphone connector + speaker
• Analog voltage control for ACD input
• 20 pin JTAG, 10 pin Cortex debug, 20 pin Cortex debug + ETM trace

Applications

Industrial, RF Communications, Consumer Electronics, Metering

Contents

Board, ULINK2 debug adapter, 2 USB A to micro B cables, MDK-ARM Lite edition, uVision IDE quick start guide.