MCB2929U

MCB2929U is a Keil MCB2929 evaluation board with ULINK2 debug adapter. Board introduces the NXP LPC2900 family of ARM9 processor based devices, allowing to create and test working programs for this advanced architecture. The MCB2929 has a wide range of interfaces making it a great starting point for ARM project. The prototyping area provides blocks for adding components and connecting to the I/O ports. The LPC2929 microcontroller provided with the MCB2929 board is a high end LPC29xx device with advanced ADC, CAN and USB capabilities. A 12MHz crystal provides the clock signal for the CPU. The JTAG interface connector provides debugging and emulator support for LPC2929 device. The JTAG interface allows application debugging and programming of on chip and off chip flash devices. Board connects the on chip serial UART to the ST3232, which converts the logic signals to RS232 voltage levels.

• 125MHz LPC2929 ARM968E-S processor based MCU in 144 pin LQFP
• On chip memory of 768KB flash, 56KB RAM, and 16KB EEPROM
• External memory: 1MB SRAM
• Colour QVGA TFT LCD with touch screen
• USB 2.0 full speed, 2 CAN interfaces
• Serial ports
• MicroSD card interface
• 5 position joystick and push button
• Analog voltage control for ADC input
• 104 GPIO pins

Applications

Industrial, Communications & Networking, Consumer Electronics

Contenu

Board, ULINK2 debug adapter, MDK-ARM evaluation tools, uVision IDE quick start guide.

Avertissements

Do not attach additional power supplies (such as batteries) while the USB supplies power to the MCB2929. This may harm PC.