410-249

410-249 is a JTAG-HS2 programming cable. The joint test action group (JTAG) HS2 programming cable is a high-speed programming solution for AMD® field-programmable gate arrays (FPGAs). The cable is fully compatible with all AMD tools and can be seamlessly driven from iMPACT™, ChipScope™, and EDK. The HS2 attaches to target boards using Digilent's 6-pin, 100-mil spaced programming header or AMD's 2x7, 2mm connector and the included adaptor. The PC powers the JTAG-HS2 through the USB port and will recognize it as a Digilent programming cable when connected to a PC, even if the cable is not attached to the target board. The HS2 has a separate Vdd pin to supply the JTAG signal buffers. The high-speed 24mA three-state buffers allow target boards to drive the HS2 with signal voltages from 1.8V to 5V and bus speeds of up to 30MBit/sec. To function correctly, the HS2's Vdd pin must be tied to the same voltage supply that drives the JTAG port on the FPGA.

• Analog Devices ADP123AUJZ linear regulator
• Small, complete, all-in-one JTAG programming solution for AMD FPGAs
• Compatible with all AMD tools
• Compatible with IEEE 1149.7-2009 Class T0 - Class T4 (includes 2-Wire JTAG)
• Separate Vref drives JTAG/SPI signal voltages; Vref can be any voltage between 1.8V and 5V
• High-speed USB2 port that can drive JTAG/SPI bus at up to 30Mbit/sec
• JTAG/SPI frequency settable by user
• Uses micro-AB USB2 connector
• SPI programming solution (modes 0 and 2 up to 30Mbit/sec, modes 1 and 3 up to 2Mbit/sec)
• Supported by Digilent's Adept S/W and Adept SDK, allowing custom JTAG/SPI applications to be created