JBM-001

DAC Hat for Pi The JustBoom DAC HAT is a plug and play, high resolution, digital-to-analog converter for the Raspberry Pi. Simply stack the plug-and-play add on board (HAT) onto your Raspberry Pi A+, B+, 2B or the new 3B and it will be ready to use immediately. Just connect your DAC HAT to a set of powered speakers or an audio amplifier and you can be up and running quickly, enjoying flawless high quality audio playback within minutes of unboxing this Raspberry Pi HAT.

• Full driver support in Raspbian / NOOBS
• Compatible with OSMC / RuneAudio / Volumio / Moode / PiCorePlayer / PiMusicBox / OpenELEC and others
• Mounting hardware included
• Full high quality audio - up to 384kHz/32 bit
• Plug and play compatibility for ease of use
• No soldering required
• Compatible with Raspberry Pi A+,B+, 2B and the new 3B
• Powered by the Raspberry Pi GPIO header
• Hardware and software volume control from your Raspberry Pi
• Fully HAT compliant
• All Raspberry Pi GPIO pins still accessible via 40pin unpopulated extension header
• Burr-Brown / Texas Instruments PCM5122 DAC chip - 384kHz / 32 bit.
• Please note that due to Linux driver restrictions, max frequency is currently limited to 192kHz by standard on the Raspberry Pi
• Texas Instruments TPA6133A2 headphone amplifier - 138mW
• Fully integrated hardware volume mixing via “alsamixer” or any ALSA compatible application
• Integrated EEPROM for automatic Raspberry Pi devicetree driver configuration and fully HAT compatible
• Optional Vishay TSOP4838 IR receiver included in package (solder yourself if required)
• 112dB signal to noise ratio (SNR) and -93dB total harmonic distortion (THD +N at -1dB) for best-in-class audio
• Advanced ESD protection on both headphone and RCA outputs
• Ultra low noise voltage regula tor for the best audio output (LDO 10uVrms)