DS2431P-A1+

The DS2431P-A1+ is a 1024bit, 1-wire EEPROM for automotive applications in 6 pin TSOC package. The DS2431-A1 is a 1024bit, 1-wire EEPROM chip organized as four memory pages of 256bits each. Data is written to an 8byte scratchpad, verified and then copied to the EEPROM memory. As a special feature four memory pages can individually be write protected or put in EPROM-emulation mode where bits can only be changed from a 1 to a 0 state. The DS2431-A1 communicates over single conductor 1-wire bus. The communication follows standard 1-wire protocol, it has its own unalterable and unique 64bit ROM registration number that is factory lasered into chip. The registration number is used to address device in a multidrop 1-wire net environment. It is used in automotive sensor identification and calibration data storage, automotive cable assembly identification and accessory/PCB identification.

• Supply voltage range is 4.5V to 5.25V
• Operating temperature range from -40°C to 125°C
• Individual memory pages can be permanently write protected or put in EPROM-emulation mode
• Switchpoint hysteresis and filtering to optimize performance in the presence of noise
• IEC 1000-4-2 level 4 ESD protection (+8kV contact, +15KV air, typ)
• Communicates to host with a single digital signal at 15.4Kbps using 1-wire protocol
• Meets AEC-Q100 grade 1 qualification requirements

Applications

Automotive, Embedded Design & Development

Remarques

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party