DS75LVU+

The DS75LVU+ is a digital thermometer and thermostat in 8 pin µSOP package. Device measures temperature using a bandgap temperature sensing architecture. It has internally filtered data lines for noise immunity (50ns Deglitch). An on-board delta-sigma analogue to digital converter (ADC) converts the measured temperature to a digital value that is calibrated in degrees centigrade and requires no external components to measure temperature. At power-up, the IC immediately begins converting temperature to digital value. The resolution of digital output data is user-configurable to 9bits, 10bits, 11bits, or 12bits, corresponding to temperature increments of 0.5°C, 0.25°C, 0.125°C and 0.0625°C respectively with 9bit default resolution at power-up. The resolution is controlled via R0bit and R1bit in the configuration register. It is used in cellular base stations, office equipment and any thermally sensitive system.

• Extended performance range with low voltage, 1.7V to 3.7V operating range
• Maximize system accuracy in broad range of thermal management applications
• Measures temperature from -55°C to +125°C & ±2°C accuracy over a -25°C to 100°C range
• User-configurable resolution from 9bits (default) to 12bits (0.5°C to 0.0625°C)
• Simplify distributed temperature-sensing applications with multidrop capability
• Easy upgrade to LM75, pin and software compatible
• Increase reliability and system robustness
• Bus timeout feature prevents lockup on 2-wire interface
• Minimize power consumption with built-in shutdown mode
• Flexible user-defined thermostatic modes with programmable fault tolerance

Applications

Sensing & Instrumentation, Communications & Networking

Remarques

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party