EG24-ILVX-Q7

EG24-ILVX-Q7 is an EG24 series precision edge measurement, retroreflective sensor for web alignment, small part detection, and width measurement. A selection of measurement modes precisely tracks edge across a broad variety of moving materials, including a wide range of opacities and textures. It is ideal for tracking the edge of a web or the location or thickness of a thin target like a thread or wire. The single-edge and double-edge tracking measurement modes can be configured, depending on the application.

• High-resolution measurement ensures material is properly positioned to improve quality and yield
• Wide sensing beam allows for precision measurement over a large area
• 24mm (0.94inch) beam width, 4mA to 20mA output current range
• Detached retroreflective sensing mode, integral 4 pin M8 connector
• 4 number of pins/wires
• IP67 rating, polarized retro sensing mode (detailed), zinc alloy die-cast primary housing material
• 0.04m emitter/receiver range, power supply range from 10 to 30VDC
• 55°C max temperature, 24mm array length, 0.01mm minimum object sensitivity

Contenu

Precision edge measurement, retroreflective sensor, Cordset single ended M8 threaded, 4-pin straight female connector, 2m (6.56ft) black PVC jacket, Nickel-plated brass coupling nut (BC-M8F4-24-2), SMBEG24RA bracket right angle - 25mm hole spacing (SMBEG24RA).

Avertissements

Do not use this device for personnel protection. Using this device for personnel protection could result in serious injury or death.