STEVAL-STLCS02V1

STEVAL-STLCS02V1 is a SensorTile connectable sensor node with solderable interface only (no connector on back side). It is a highly integrated reference design that can be plugged into form-factor prototypes, adding sensing and connectivity capabilities to new designs through a smart hub solution. It can also easily support development of monitoring and tracking applications like standalone sensor nodes connected to iOS™ or Android™ smartphone applications. The SensorTile occupies a very small 13.5mm x 13.5mm square outline with all the electronic components on the top side and a small connector on the bottom side to plug it onto the cradle expansion board. The connector pin out is repeated on 18 PCB pads to render the SensorTile a solderable system on module as well. It is a very compact module for motion, audio, environmental sensing and Bluetooth® low energy connectivity with a complete set of firmware examples.

• STM32L476 32bit ultra-low-power MCU with Cortex® M4F IC
• LSM6DSM 3D accelerometer and 3D gyroscope iNEMO inertial module
• LSM303AGR ultra-compact high-performance eCompass module
• LPS22HB MEMS nano pressure sensor
• MP34DT04 64dB SNR digital MEMS microphone
• BlueNRG-MS Bluetooth low energy network processor
• BALF-NRG-01D3 50 ohm balun with integrated harmonic filter
• LD39115J18R 150mA, 1.8V, low quiescent current, low noise LDO
• Power supply range from 2V to 5.5V, SWD interface for debugging and programming capability
• UART, SPI, SAI, I²C, DFSDM, USB OTG, ADC, GPIOs external interfaces