ENW89841A3KF

The ENW-89841A3KF is a Wireless UART Interface Module used for communication between the host and PAN1322-SPP. The lines UARTTXD and UARTRXD are used for commands, events and data. The lines UARTRTS and UARTCTS are used for hardware flow control. Low power mode control of PAN1322-SPP and the host can be implemented in by using the pins P0.14 and P0.0. P0.14 is used by the host to allow PAN1322-SPP to enter low power mode and P0.0 is used by PAN1322-SPP to wake-up the host when attention is required. Additionally, the host could hardware reset PAN1322-SPP using the RESET pins. Power is supplied to a single VSUPPLY input from which internal regulators can generate all required voltages. The UART and the GPIO's interfaces have separate supply voltages so that they can comply with host signalling.

• Implements a single point-to-point data link to other SPP capable Bluetooth devices
• Ultra low power design in 0.13μm CMOS
• On-module voltage regulators
• On-module EEPROM with configuration data
• On-module tuned reference clock
• Module can enter low power mode in idle state and during sniff intervals
• AT command interface over UART with HW flows control
• Default UART baud rate 115200bps
• Module configuration reprogrammable for 9600-bit/s up to 3.25Mbps UART baud rate
• JTAG for boundary scan in production test
• -86dBm Typical receiver sensitivity
• Secure simple pairing
• Single point-to-point data link, role switch supported
• Packet data mode and stream data mode supported
• Sniff mode and sniff sub-rating is supported with above capabilities
• 5 Trusted devices stored in EEPROM

Applications

Wireless, Communications & Networking