RPA20-2415DAW-HC

The RPA20-2415DAW-HC from Recom Power is a RPA20-AW series 20W dual output DC to DC converter without control pin and with glued heatsink. This high power density converter has 4:1 wide input voltage range and industry standard 1”x1” case size. Despite its small size, the RPA20-AW converter is fully specified device with high efficiency, no minimum load, 1600VDC isolation, tight regulation and low ripple/noise figures. The outputs are also fully protected against overtemperature, short circuits, overcurrent and overvoltage. The converter finds many uses in railway applications where board space is at a premium. It has Pi-type internal input filter.

• Input voltage range from 9VDC to 36VDC (24VDC nominal input voltage)
• Output voltage of ±15VDC and output current of ±670mA
• Input current of 960mA
• Efficiency of 88% and maximum capacitive load of ±680μF
• Line regulation of ±0.1% typical and ±0.5% maximum (low line to high line)
• Load regulation of ±1%
• Start-up time of 8ms (power-up, CTRL ON/OFF) and internal operating frequency of 550KHz
• Ripple and noise of 50mVp-p and output accuracy of ±0.1% (typical), ±2.0% (maximum)
• Minimum isolation resistance of 10Mohm and typical isolation capacitance of 1100pF
• Maximum case temperature of 105°C

Applications

Power Management, Industrial

Notes

An input fuse is required if the mains supply is not overcurrent protected. Recommended fuse is 3A slow blow type.